Control Panels
The Elcos designed and manufactured QPE-C control panels are automatic mains failure panels (AMF panels) using sophisticated microprocessor circuitry to monitor both the overall generator and engine performance.
The panel is equipped with a three-positioned key that sets the type of operation:
- With the key in 0 position, both the panel and the generating set are o ff.
- With the key in manual, the start-up is initiated by the operator by pressing the “start” button.
- With the key in automatic, depending on the operation mode, start-up can be initiated via an external contact: mains failure, MODBUS control, or a mobile SMS message.
During operation, all the electrical and mechanical parameters of the generating set are shown on the display and all protections are activated, including: overload, short-circuit and earth fault if provided.
If a fault occurs, the opening coil will open the switch, disconnecting the load and after a cooling-down period, the engine will stop.
Combined with an Automatic Transfer Switch (ATS), the QPE-C provides complete generator protection from mains power supply failures.
Teleprocessing software for monitoring and configuration is supplied as part of the QPE-C control panel package. Other remote monitoring options include:
- Remote display panels
- 4 alarm module
- 14 alarm module
- Remote control modem
- Start and Stop remote control (600m maximum)
A full set of generator and related containers, shelters and accessories datasheets can be found in the resources area of this website.
Modem For Remote Control
Modulate Raising 14 Alarms
Modulate Raising 4 Alarms
Remote Display for QPE-C
Start and Stop Remote Control
Teleprocessing for QPE
